Veo Observer User Manual download pdf (Page 29)

VIPN1100 Veo Europe IP Netcam Manual rev 1.2 EN -

29 -

Default Gateway.

More information regarding WINIPCFG can be obtained by typing in: winipcfg /? at the MS

-DOS prompt.

WINIPCFG is located in the C: \Windows folder.

Windows 2000/XP:

1. Click on Start  Run and type in: command and then press ENTER

2. In the MS- DOS window, type in: ipconfig and then press ENTER

3. This will display your network card’s IP Address, Subnet Mask, and Default Gateway.

More information regarding IPCONFIG can be obtained by typing in: ipconfig /? at the MS -

DOS prompt.

IPCONFIG is located in the C: \Windows \System32 folder.

11-2. Using PING

PING is a very useful utility for checking to see if a camera is responding or checking to see if

an IP address is available. In Windows 98/Me, PING is located in C: \Windows. In Windows

2000/XP, PING is located in C: \Windows \System32.

Windows 98/Me/2000/XP:

1. Click on Start ->Run and type in: command and then press ENTER

2. In the MS- DOS window, type in: ping XXX.XXX.XXX.XXX and then press ENTER

(where XXX.XXX.XXX.XXX is your IP address) For example, if your Camera uses the IP

address of 123.123.123.1, you would type in: ping 123.123.123.1

3. If there is a camera, or a PC or other network device online and using this address you

will see:

Pinging 123.123.123.1 with 32 bytes of data:

Reply from 123.123.123.1: bytes=32 time<1ms TTL=128

1 2 ... 24 25 26 27 28 29 30

No comments

Veo Observer User Manual Page 29